the end result and the drawing isnt exactly the same. The 10mm surface when connected to the 30diameter hole (from the side) does not have parting lines (based on drawing) but in the tutorial there is line. Im just wondering if there is any way to make the line disapper? Also, Thanks for wonderful tutorial i learned a lot from your video
Sir ..I continue learn solid work ..but my system may not working properly ..plz tell what type of graphics ram uses …to flunt Run solid work ..plz help me out
Wonderful tutorial
????????????????????
TÜRKİYEEEE
thank you very much. your videos are very helpful.
You are the best
very nice ????
Adam. Thanks for exercise dude.
Good sir
Can't draw Rib in SW2020, it ask me to select body 🙁 Would you check this monent?
I'm not able to do rib by doing same process ????. Plz explain anyone
Thank you very kindly!
sir plz send the safed file of this now
I have gone the same process but during rib there's one option selected a body, i don't no which body we need to select
thank you
Thank you for the exercise…
the end result and the drawing isnt exactly the same. The 10mm surface when connected to the 30diameter hole (from the side) does not have parting lines (based on drawing) but in the tutorial there is line. Im just wondering if there is any way to make the line disapper? Also, Thanks for wonderful tutorial i learned a lot from your video
Done
Sir ..I continue learn solid work ..but my system may not working properly ..plz tell what type of graphics ram uses …to flunt Run solid work ..plz help me out
thx sir
I tried this tutorial in solid works 2018 but i face some difficulties in extruding 10mm face.